4, double mutual transfer settings

Gancheng motion control card, how to set up double-headed mutual transfer function?
Double-head interactive function to open and set, the main three steps, the specific way is as follows:

The first step: the panel to open double-headed mutual transfer settings.
1, hold down the stop key + Shift key at the same time in the panel, the following interface appears:
 
The company is located in:
2, select the first six long mutual transfer settings, click to enter the setup interface. Set the number of reciprocal axes to 2, ZX axis spacing is reset after the two laser heads together the minimum.


Step 2: Set the pulse equivalent of Z axis by jogging control.
1, the first point shot, write down the location of mutual head RBI.
2, press the menu button to enter the system menu interface, select "jog control" option.

3, by up and down keys or left and right keys to set the jogging distance of 200MM.

4, press the button to move the Z axis jog, and then click the left or right button, and then press the exit button, and then click the button. Hand out the amount of the first two points of mutual transfer of the first point of shooting distance.
5, press the stop key + Shift key to enter the axis parameters, modify the pulse equivalent of the Z axis.

 
The length of the graphic is the distance just moved (200mm); the measurement length is the actual distance just before measuring two points. After input, press the OK button, then press the reset button OK.

The third step: software layout.
1, the array parameters set typesetting map, first into the typesetting a single graphic, and then find this symbol to fill in the number of columns to be processed, the number of rows, pay attention to the graphics must be a single graphic is a solid line, the other is all dashed.

Note that the use of line mirroring and column mirroring, such as: cut 6 column diagram, sometimes select the column mirror, resulting in a cut two, the other cut four reasons for this. Because sometimes through the mirror, the map is too deep, in order to avoid switching materials, then the equivalent of two figures into a map.
2, if the material there is spare part, in order not to waste material, you can choose to cut into trim.
3, import or draw their own graphics to be processed, and then edit the point of conversion into scrap.

As shown, the red rectangle is the scrap

4, in the panel can choose cutting near the corner, so which corners near the head, which head will be cut in the past.

5, the customer on the laser head to go the path requirements, for example: the origin of the machine in the upper right corner, the laser head from the top right corner of the table to start cutting, then press the following actions: First, the machine zero position and page zero position settings, such as Picture shows:

Then, the relative position of the graph:

Then, click to load the current document, re-optimize the cutting path, as shown:

Inter-block spacing refers to the height of a single graphic in the Y-direction, which is slightly larger than the height of a single graphic in the Y-direction. Finally, the laser head to the bottom right corner of the platform, press the positioning key (usually select the panel key positioning mode), even if the setting is completed.
Similarly: 4 sets of mutual transfer of more V and W axis, only need to shift the number of axes selected as 4, then add the ZV spacing and VW spacing OK.