5, using the machine to complete the installation process

1, the first laser computer installed in the computer software (laser cad), including the USB driver, you can choose to install Coreldraw, Auto CAD, Illustrator CS plug-in see the instructions.
2, open the package, check the shell and the like, see there is a crush and the like, the machine is drenched over water, wire, gongs like whether there is off, loose, reflective environment, focus is not partial, If too bad, please correct.
3, the installation of a laser tube, connected to a good tank, it must be to ensure that the laser power connected to the laser tube, the water tank has been opened, the water cycle, or put the laser power switch off if you want to proceed to the following steps.
4, pull the laser head to the middle of the machine, boot power, observe the laser head back to the origin of the right direction, if not right, immediately press the stop button on the panel.
5, press the stop key on the panel + SHIFT key, enter the first axis parameters. Enter the X-axis, modify the X-axis back to the origin direction, if the X-axis back to the origin of the anti-reversal, as long as the anti-change OK, if the key in the opposite direction, the direction of the key set anti.

机器最大行程也可以同时修改，同理Y轴也一样，改完之后按确定键，然后再按复位键，修改后的参数则会有效。

6、调节光路，一般新机器发到厂家，长途运输肯定有波动，所以光路都要调一下。检验光路对不对。

7、查验机器的脉冲当量值是否对的（一般情况下是对的）。在软件画一个200*200的正方形后，加载到主板，然后按定位键，再按开始键，让机器切割此方形，然后用尺 测出实际切割出来的值，如果是准确的，那说明机器脉冲当量值是对的，否则进行下面的方法，在面板上按停止键+SHIFT 键，进入第一项轴参数。

8：验证机器幅面大小，机器实际台面多大，请设置多大幅面，确保机器从最近端（原点）跑到最远端，激光头不会撞，这个值就是机器幅面大小，可以通过面板显示的X Y 坐标值获取。

9：以上检测完成，其它可以交付客户使用。